6
Checking Accessories
Cable clamper × 2 Power cord Remote controller × 1 AA battery × 2
User’s Manual × 1 Bracket × 2 (2 type) Screw × 2 (2 type) Key × 2
Operating Guide × 1
Cable clampers
• The accessory cable clampers are for fastening the connected
signal cables and a power cable. When installing this display
on a wall or ceiling, insert the cable clampers into the holes on
the rear of the display.
∗ When connecting separately pur-
chased BNC terminals, conversion
connectors are required between the
pin jacks and the BNC terminals, so
purchase these also.
∗ Cables connecting the personal com-
puter vary according to the type of
machine, so consult your product
dealer.
ACCESSORIES
Connecting to External Equipment
Cables for connecting external equipment must be
purchased separately.
AB
Screw A (10 mm)
Screw B (20 mm)
USER’S
MANUAL
OPERATING
GUIDE
Cable clamper
(Attach as in the illustration.)
Bundle connecting cables so
that they lead downwards, as
in the illustration.
RS-232C
RGB INPUT
VIDEO INPUT
COMPONENT
VIDEO INPUT
(color difference
input)
AUDIO INPUT
SYNC SW
TTL/ANALOG (75Ω)
S-VIDEO
INPUT
To component
video output
terminal
Connecting to AV equipment
Connecting to PC
To RS-232C
terminal
Display
(to analog
RGB
output
terminal)
To S-video
output
terminal
To video
output
terminal
To audio
output
terminal
Connectors
AUDIO INPUT Pin jack
VIDEO INPUT BNC
S-VIDEO INPUT S terminal
COMPONENT VIDEO INPUT
BNC
RGB INPUT 15-pin mD-sub
RS-232C 9-pin D-sub
Floppy Disk for Installing
PC Card Utility for
Plasmavision × 3
PDS4204W-H × 3
PDS4204E-H × 1
