A SERVICE OF

logo

11
ENGLISH
Rear view
Power switch
When pressed, power lamp lights red, and the
power can be turned on or off by the remote control-
ler. When this switch is pressed again, the power is
cut and power lamp goes off.
Power input terminal
Firmly insert the accessory power cord as far as it will
go into the power input terminal.
Firmly push the power cord plug as far as it will go
into the power socket (100–240 VAC).
Video input terminal (VIDEO INPUT)
Connects to the video output terminal of a video deck
or video disc player.
S video input terminal (S-VIDEO INPUT)
Connects to the S video output terminal of a video
deck or video disc player.
Component video input terminal (COMPONENT
VIDEO INPUT)
Connects to the component video output terminal of
DVD, and similar devices.
RGB input terminal (RGB INPUT)
Connects to the computer monitor's (analog RGB)
output terminal.
Cables connecting the personal computer vary ac-
cording to the type of machine, so consult your prod-
uct dealer.
AUDIO
INPUT
RGB
INPUT
RS-232C
SYNC
SW
TTL
ANALOG
(75)
CONPONENT
VIDEO INPUT
VIDEO
INPUT
S-VIDEO
INPUT
RL
RS-232C input terminal (RS-232C)
Connects to the computer RS-232C output terminal.
Audio input terminals (AUDIO INPUT)
Connects to the audio output terminal of a video deck
or similar device.
Sync switch (SYNC SW TTL/ANALOG (75 ))
For switching the RGB terminals' 13-pin horizontal
sync and 14-pin vertical sync to terminate with 75 .
When an analog synchronous signal is input at the
RGB terminal, be sure that this switch is set to ANA-
LOG (75 ). For connection to a personal computer,
be sure it is set to TTL.
PC card slot
Where the PC card is loaded and unloaded. This can
be locked with the accessory key.
PC card access lamp
Lights while the PC card is being accessed.