A-4 Product Specifications of the TM-C100 Rev. C
[Bi: bidirectional printing]
[Uni: unidirectional printing]
Note:
1. Printing speed is with continuous printing without cleaning, auto-cutting, or paper feed or ejection.
2. Printing speed may be slower, depending on the data transmission speed, status receiving and so on.
A.3 Roll Paper Specification
Note:
Print quality may fall when printing immediately after installing the roll paper.
Item Specification
Autocutter Cutting method: Circular cutter
Cutting type: Full cut
Minimum cut length: 15 mm
Roll paper holder Supply method: Axial
Roll paper detection: TOF/BOF sensor
Paper near-end detection: No
Paper width selection: Selectable from 45 mm to 105 mm
Paper width detection: No
Roll paper holder detection: Yes
Paper feed specifications Paper feed type: Friction feed
Continuous paper feed speed: approximately53 mm/s
Paper specifications Paper type: Plain paper/special paper (special fine paper, special matte
paper)/plain borderless label paper (scraps on both sides:
width 1 mm)
Form: Roll paper
Paper width: 45 to 105 mm
Paper thickness: 0.06 to 0.23 mm
Basic weight: 52.3 to 200 g/m
2
(JIS P8124)
(45 to 173 kg / 1,000 sheets / 788 × 1,091 mm)
Outside diameter: Maximum φ90 ± 1 mm
Core: Inside diameter 38 mm, outside diameter 44 mm (cannot be
pasted with paper)
Roll length: Plain paper approximately 61 m
Borderless label paper approximately 37 m
Special fine paper approximately 40 m
Special matte paper approximately 20 m
Roll direction: Top-side roll
Holes and cutouts: No holes or cutouts in the roll paper are permitted.
Mass Roll paper specification: Approximately 2.0 kg
ASF specification: Approximately 1.9 kg
