EPSON AcuLaser C1100 Revision B
TROUBLESHOOTING FIP according to the printer message 184
FIP-35
Panel Message
Jam D, E, DM
Possible parts that caused the error
Troubleshooting
ROLLER ASSY INVERTER ROLL PINCH DUP
ROLL ASSY PINCH DUP FUSER ASSY
MOTOR ASSY DUP INV ROLLER ASSY DUP
ROLLER ASSY DUP OUT ROLL PINCH DUP
MOTOR ASSY DUP PWBA DUP-L
ROLL ASSY-PRE REGI ROLL-PINCH
ACTUATOR-REGI SENSOR REGI
HARNESS-ASSY P/H1 HARNESS-ASSY P/H2
PWBA MCU LV/HVPS
MOTOR-PH HARNESS ASSY MAIN
CLUTCH ASSY PRE REGI
Step Check Yes No
1
Paper check at SENSOR UPPER PASS section
Open Duplex.
Is there any paper remaining at the SENSOR
UPPER PASS section?
Remove the
remaining paper
and proceed to
Step [2].
Go to Step [9].
2
Check of Duplex attachment
Open and close Duplex.
Also, disconnect and re-attach the connector
from the printer to Duplex.
Does the error recur when a test print is made
in the duplex mode?
Go to Step [3]. End of
procedure
3
Check of ROLLER ASSY INVERTER,
ROLL PINCH DUP, and ROLL ASSY
PINCH DUP
Open Duplex.
Are ROLLER ASSY INVERTER, ROLL
PINCH DUP, and ROLL ASSY PINCH DUP
attached correctly?
Also, do these parts rotate smoothly without
any dirt or damage?
Turn by hand to check.
Go to Step [5]. Replace or re-
attach ROLL in
question, and go
to [4].
4
Does the error recur when a test print is
made in the duplex mode?
Go to Step [5]. End of
procedure
5
Check of paper position
Is the leading edge of the paper passing
through ROLLER ASSY INVERTER?
Go to Step [6]. Replace FUSER
ASSY. (p.388)
6
Check of transmission of drive force of
ROLLER ASSY INVERTER section
Open Duplex.
Remove COVER-INV, COVER-R DUP, and
COVER-L DUP (p.415), (p.413) and (p.414)
Are all gears that transmit rotation of MOTOR
ASSY DUP INV to ROLLER ASSY
INVERTER turning smoothly?
Turn gears by hand to check.
Go to Step [7]. Replace the
gear in question.
7
Check after replacement of MOTOR ASSY
DUP INV
Replace MOTOR ASSY DUP INV. (p.424)
Does the error recur when a test print is made
in the duplex mode?
Go to Step [8]. End of
procedure
8
Paper check at SENSOR LOW PASS section
Open Duplex.
Is there any paper remaining at the SENSOR
LOW PASS section?
Remove the
remaining paper
and proceed to
Step [9].
Go to Step [14].
Step Check Yes No
