Stylus Photo R300/R310 Revision A
DISASSEMBLY AND ASSEMBLY Disassembly 52
External View
Figure 2-21. Removing "Holder, Shaft Assy." (2)
Removing "LD Roller"
1. Release the dowels (x2) which secure "Paper, Block". Then, remove "Paper,
Block".
2. Release the dowels (x2) which secure "Shaft, LD Roller". Then, remove
"Shaft, LD Roller" and "Clutch" together from "Holder, Shaft, LD Roller".
3. Remove "LD Roller" from "Shaft, LD Roller".
Paper, Block
Spur Gear, 36.8
Clutch
Extension Spring, 0.143
Shaft, LD Roller
Dowel
PE Sensor Board
Hook
Torsion Spring, 0.22
Lever Sensor, PE
Holder, Shaft, LD Roller
LD Roller
Dowel
Dowel
Dowel
C A U T I O N
Do not touch "LD Roller" with bare hands.
Reinstalling "LD Roller"
Make sure to match the direction ( Mark) indicated on
"Shaft, LD Roller" and the direction ( Mark) indicated on
the back side of "LD Roller".
Figure 2-22. Position of "Torsion Spring, 137.7"
mark on "Shaft, LD Roller"
mark on "LD Roller"
