Level 1 Options
Each submenu is explained below.
l FULL PRINT — The default setting of 0 is sufficient for most
uses of the printer. If you are printing complex pages, you may
need to increase the setting. If the printer displays the message
SET FULL PRINT, increase this setting. The setting (any
number from 0 through 62) times 20 is the number of kilobytes
(KB) reserved in RAM for page composition. For example, a
setting of 5 reserves 100KB.
Menu/submenu
Available options
0
to
62
I
The following table shows the maximum setting necessary for
each size of paper. The setting may be lower than the
maximum, but it will never need to be higher.
Paper Size
A4
A5
B5
LT
HLT
LG
GLT
Setting
Paper Size
51
GLG 57
35
EXE
45
43
F4 57
47
MON
31
36
C10
41
62
DL
37
45
C5
38
Setting
Since the amount of RAM you reserve with this option is not
available for any other purpose, it is best to leave the setting at
0 until you see a SET FULL PRINT message. Then, increase the
setting in small increments until the error does not occur.
If FULL PRINT is set to the maximum value, the printer does
not display the SET FULL PRINT error. If an INSUFF
MEMORY or PAGE BUFFER FULL message appears, you must
install optional memory. See Chapter 7 for information on
installing additional memory.
3-18
SelecType
