English
Tu r ning on and Projecting
• When using the "Direct
Power ON" feature, the
power turns on when the
power cable is connected.
• When using above an
altitude of about 1500 m,
set the "Fan Speed" to
"High".
User’s Guide "Extended
Menu"
No image is projected
For notebooks and computers with liquid
Enlarge Reduce
(Accessory
Power Cable)
* For video equipment,
press "play" to start
playback.
Control Panel
Remote Control
Power Indicator
crystal displays
Change the computer’s
output source. Hold
down the
key and
press the appropriate
key (the one usually
labelled
/ ). After
changing the setting,
wait a few seconds for
projection to start.
Computer’s "User’s
Guide"
* If the image is not
projected, press
.
For video equipment
Start playback then
press
.
Adjusting Position and Focus
(Setting up for the first time or after moving)
Raising the Projection Position (Adjusting the front foot)
When moving the projector, make sure
the front foot is retracted.
Foot Adjust
Lever
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum of
about 30°*(20° when projecting a component
video image with a ratio of 16:9).
* The greater the angle of tilt, the harder the
image is to focus. Setup the projector at a lower
angle of tilt.
Adjusting Focus
After keystone correction and
sharpness adjustments, the image
may be unfocused.
If keystone correction or zoom adjustments are performed, the "Image Shift" adjustment screen is
displayed.
User’s Guide "Adjusting the Projection Position (Image Shift)"
Turning the Projector off
NormalWide Top Wide Base
You can adjust the front foot to raise the
projection angle up to a maximum of 10°.
Extend Retract
Turn off all connected equipment.
Press twice on the remote
control or control panel.
After the confirmation buzzer beeps
twice, unplug the power cable.
Electricity is consumed if only the projector's
power is turned off.
Attach the lens cover.
Examples
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh
Set mirror setting
or display
detection.
In this mode pressing
has
no effect.
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
Rear Adjustable
Foot
• You can also make keystone
corrections from the configuration
menu.
User’s Guide "Settings Menu"
• Hold down
and press for more
than one second to reset the
correction value to the default
setting.
• Adjust the horizontal tilt by turning
the left rear foot.
Lit
Flashing
Orange
Standby
Press
to start
projecting.
Green
Green
Warming up
Wait for a short
time (about 30
seconds).
Projecting
In this mode, you can unplug
the power cable.
Reading the Indicators
Adjusting Projection Size
