Status and Error Messages
[E] SET FULL PRINT
This message may appear when you are trying to print graphics
or a
mix
of text and graphics. Press
CONTINUE
and then change
the FULL PRINT setting in SelecType Level 1. See Chapter 4 for
more information about this setting.
[S] STANDBY MODE
If the standby mode is enabled, the printer enters this mode
when it is not used for about thirty minutes. Even if the standby
mode is disabled, the printer enters standby mode when it is not
used for eight hours. When this message appears, press any
control panel button or send data to the printer to warm it up.
[W] TONER LOW
The printer is almost out of toner. When you see this message,
you can still print up to 20 more pages. Then you must replace
the toner cartridge.
[E] TONER OUT
The toner cartridge must be replaced, as described in Chapter 6.
[E] TRAY SET XXX
The paper-size setting does not match the paper loaded in the
specified paper cassette. The right column of the display
indicates the currently selected cassette and the expected paper
size. You can either change the paper-size setting or load the
correct paper size. After you correct the paper mismatch, press
CONTINUE.
[S] WALT
The printer is being reset after a startup error.
[S] WARMING UP
The printer is warming up.
Troubleshooting 7-7
