Setting Up the Projector 17
Connecting a Component Video Cable
If your video source has component video connectors, you can use
them to project a higher quality video image. You’ll need a
component video to VGA cable, which can be purchased from
EPSON (ELPKC19). See page 7.
Before starting, make sure the projector and your DVD player or
other video device are turned off.
1. Connect the large end of the component video cable to the
projector’s
Computer/Component Video
port.
2. Insert the three ends of the component video cable into the
R
,
G
,
and
B
ports on your video source.
3. After you turn on the projector, use the Video menu to set the
Input Signal to
YCbCr
or
YPbPr
. See page 34 for more
information.
52c.book Page 17 Wednesday, October 9, 2002 2:32 PM
