A SERVICE OF

logo

Open as PDF
next previous
54
Setting
Display
This function decides whether to display On-Screen Displays.
On ............................ Show all the On-Screen displays. Use
this function when you want to project
images after the lamp becomes bright
enough. The factory default setting is
in this option.
Countdown Off ........ Show the input image instead of
the countdown when turning on the
projector. Use this function when you
want to project the image as early as
possible even when the lamp is not
bright enough.
Off ........................... Hide the On-Screen Displays except;
lOn-Screen Menu
l“Power off?” (p.25)
l“No signal” for Power management
(p.55)
l“Please wait ...”
lArrows for panning mode(p.47)
Display
Use the Point 7 8 buttons to
switch between the options.
Standby mode
This function is available when operating the projector via
network.
Normal ....... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco............. Select “Eco” when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
✔Note:
•Whenselecting“Normal”,thecooling
fansmayberunningdependingonthe
temperatureinsidetheprojectoreven
iftheprojectoristurnedoff.
•When“Eco”isselected,several
functionswillberestricted.(pp.17,20-
22,53,55)
• When“Eco”isselected,allofthe
infraredremotereceiversareactivated
regardlessoftheRCsensorsetting.
Theprojectormaybeeffectedthe
noiseofthefluorescentlightandso
on.
Power management
Time left before the lamp is off.
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the projector is not used for a certain period.
If the input signal is interrupted and no button is pressed for more
than 30 seconds, the timer display with “No signal” appears. It
starts the countdown until the lamp is turned off. The countdown
time can be set between 1–30 minutes. Use the Point 7 8
buttons to set the countdown timer.
Power management