A SERVICE OF

logo

Open as PDF
next previous
25
Press the ON/STAND-BY button on the top control
or the STAND-BY button on the remote control, and
“Power off?” appears on the screen.
Press the ON/STAND-BY button or the STAND-BY button
on the remote control again to turn off the projector. The
POWER indicator starts to blink red. After the projector
is turned off, the cooling fans operates for 90 seconds.
During the POWER indicator is blinking, you cannot turn
on the projector.
1
2
TO MAINTAIN LIFE OF THE LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST FIVE
MINUTES BEFORE TURNING IT OFF.
DO NOT UNPLUG THE AC POWER CORD WHILE
THE COOLING FANS ARE RUNNING OR BEFORE
THE POWER INDICATOR STOPS BLINKING.
OTHERWISE IT WILL RESULT IN SHORTENING
THE LAMP LIFE.
3
When the projector has cooled down enough, the
POWER indicator stops blinking and you can turn
on the projector. After it is cooled down completely,
unplug the AC power cord.
“Power off?” disappears after 4 seconds.
✔Notes:
•WhentheOnstartfunctionissetto“On,”the
projectorwillbeturnedonautomaticallyby
connectingtheACpowercordtoanACoutlet(p.55).
•Therunningspeedofcoolingfansischanged
accordingtothetemperatureinsidetheprojector.
•Donotputtheprojectorinacasebeforethe
projectoriscooledenough.
•IftheWARNINGTEMP.indicatorblinksoremitsred
light,see“WarningIndicators”onpage66.
•WhilethePOWERindicatorisblinking,thelamp
isbeingcooleddownandtheprojectorcannotbe
turnedon.WaituntilthePOWERindicatorstops
blinkingtoturnontheprojectoragain.
Turning Off the Projector
DO NOT OPERATE THE PROJECTOR
CONTINUOUSLY WITHOUT REST. CONTINUOUS
USE MAY RESULT IN SHORTENING THE LAMP
LIFE. TURN OFF THE PROJECTOR AND LET
STAND FOR ABOUT AN HOUR IN EVERY 24
HOURS.
Basic Operation