A SERVICE OF

logo

Open as PDF
next previous
Line Commands
exec-timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 244
18
Example
The following example configures the line baud rate.
Console(config)# line console
Console(config-line)# speed 115200
exec-timeout
The exec-timeout Line Configuration mode command sets the interval that the
system waits until user input is detected. Use the no form of this command to
restore the default configuration.
Syntax
exec-timeout
minutes
[
seconds
]
no exec-timeout
Parameters
•
minutes
— Specifies the number of minutes for the timeout. (Range: 0-
65535)
•
seconds
— Specifies additional time intervals in seconds. (Range: 0-59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
To specify no timeout, enter the exec-timeout 0 command.