CHAPTER
Send document comments to nexus7k-docfeedback@cisco.com
5-1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
5
Connecting the Cisco Nexus 7000 Device to the
Network
This chapter describes how to connect the Cisco Nexus 7000 Series device (configure its IP address
through a console, set up its management interface, and connect its Ethernet ports to the network) after
it has been installed in its rack or cabinet.
This chapter includes the following sections:
• Preparing for Connections, page 5-1
• Required Tools and Equipment, page 5-1
• Connecting to the Console, page 5-2
• Creating an Initial Device Configuration, page 5-3
• Setting Up the Management Interface, page 5-4
• Connecting the Supervisor CMP Port, page 5-5
• Connecting an I/O Module, page 5-5
Preparing for Connections
When preparing your site for network connections to the Cisco Nexus 7000 Series device, consider the
following for each type of interface:
• Cabling required for each interface type
• Distance limitations for each signal type
• Additional interface equipment needed
Before installing the device, have all additional external equipment and cables available.
Required Tools and Equipment
• Console cable connector kit—You can find this kit in the accessory kit, which ships with the Cisco
Nexus 7000 Series system.
• Network cabling—You have already routed the network cables to the location of the installed Nexus
7000 Series device.
