A SERVICE OF

logo

6-16
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 6 Maintaining the Cisco MGX Switch or Gateway
Removing the Center Guide Modules
Figure 6-8 Removal of the Center Guide Module
Step 4 Carefully push the vertical support bracket straight downward approximately 1/2 inch, tilt the top leg of
the support toward you until it clears the top of the card cage, and then pull the bracket to remove it from
the card cage.
Step 5 Locate the jack screw (see Figure 6-9) behind the hole in the faceplate of the center guide module. Use
a flat-blade screwdriver to loosen the jack screw at least five complete rotations counterclockwise to
disengage the module from the card cage.
48460
Bulkhead
Center guide module
Removing
vertical suport
bracket