6-26
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 6 Maintaining the Cisco MGX Switch or Gateway
Installing or Removing Redundancy Connectors
Step 5 Place the RCON assembly over the RCON mounting bar, positioning the RCON alignment flange over
the right of the bar and the RCON alignment pins through holes in the bar; then tighten the two fasteners
(See Figure 6-15).
Note Be careful not to bend or damage the pins on nearby back card connectors.
Figure 6-15 MGX 8830/B RCON Installation
Step 6
Install a second RCON in the other bay, if desired.
Step 7 Reinstall all filler bars.
Step 8 Reinstall all back cards.
Step 9 Restore power.
1 Alignment hole for RCON 5 Alignment flange on RCON assembly
2 Mounting flange for RCON 6 Mounting screw on RCON assembly
3 Alignment pin on RCON assembly
4
3
5
146509
1
2
