18
Did you start a browser
session on your PC before
the SETUP LED was solid
green?
If yes, or you are not sure, restart
the switch. Perform Step 2
through Step 6. When the SETUP
LED is solid green, start a browser
session on your PC. Complete the
set-up procedure.
Did you start a browser
session on your PC and
the set-up page did not
appear?
If the window does not appear,
enter a URL in your browser, such
as cisco.com, or another
well-known website.
Did you have a pop-up
blocker running on your
PC when you connected
to the switch port?
If yes, disconnect the cable from
the switch port, disable the
pop-up blocker, and reconnect to
the switch. Press the SETUP
button to continue.
Did you have proxy
settings enabled in your
browser software when
you connected to the
switch port?
If yes, disconnect the cable from
the switch port, disable the proxy
settings, and reconnect to the
switch. Press the SETUP button to
continue.
Did you have a wireless
client running on your PC
when you connected to
the switch port?
If yes, disconnect the cable from
the switch port, disable the
wireless client, and reconnect to
the switch. Press the SETUP
button to continue.
Do you need to change
the switch IP addressafter
you have already
completed the initial
setup?
Go to the Configure > Express
Setup device manager screen to
change the switch IP address. For
more information about changing
the swith IP address, see the User
Guide for the Catalyst Express
500 Switches online at Cisco.com.
Checklist Recommendation
