3-10
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
Chapter 3 Power Supply Installation
Power-Supply Module Installation
Figure 3-11 Stripping the Input Power Source Wire
Step 5 Insert the wire into a spade terminal, and crimp it to the wire. You can also use a ring or flanged spade
terminal as listed in the “Equipment That You Need” section on page 3-4.
Figure 3-12 Crimping the Spade Terminal Lug
Step 6 Loosen the terminal screw, and slide the terminal under the screw and washer. See Figure 3-14.
Note Use the appropriate terminal screws, depending on whether you are installing a high-voltage (AC or DC)
or a low-voltage (DC) power supply.
Step 7 To connect the AC power:
a. Connect the line wire into the terminal screw labeled L and the neutral wire into the terminal
screw labeled N.
b. Make sure that you cannot see any wire lead. Only wire with insulation should extend from the
terminal screw.
0.25 in. (6.3 mm)
±
0.02 in. (0.5 mm)
60531
