CHAPTER
3-1
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
3
Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships
with at least one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable.
For translations of the safety warnings in this chapter, see the Regulatory Compliance and Safety
Information for the Cisco IE 3010 Switch on the documentation CD and also on Cisco.com.
• Power-Supply Modules, page 3-1
• Installation Guidelines, page 3-3
• Grounding the Switch, page 3-4
• Installing the Power-Supply Module in the Switch, page 3-6
• Wiring the Power Source, page 3-7
• Removing the Power-Supply Module, page 3-12
Power-Supply Modules
For information on the power-supply modules, see the “Power Supply Features” section on page 1-14.
Table 3-1 Power-Supply Modules
Model Description
PWR-RGD-LOW-DC/IA Low-voltage DC. For voltage information, see Table A-6 on page A-4.
PWR-RGD-AC-DC/IA High-voltage AC or DC. For voltage information, see Table A-5 on
page A-4.
