Bully Dog 40366 v1.0.0 Manual

A SERVICE OF

next previous



Monitor



Bully Dog oﬀ ers three diﬀ erent options for mounting the OutLook Monitor. Each lo-

cation option places the OutLook Monitor in an easily accessed viewing area for the

driver.



1. Locate the windshield mount included with the OutLook Moni-

tor as seen in. This does not come with mounting glue. Glue that

will adhere metal to glass can be found at any hardware store.

2. Place glue onto the window mount piece with the OutLook

Monitor holder detached from the windshield mount piece.

3. Hold the windshield mount piece on the windshield just to the

left of the steering wheel for one minute.

4. Let the glue set up as instructed by glue packaging and then slide

the OutLook Monitor holder onto the window mount with the Out-

Look Monitor attached.



1. Locate the OutLook Pod Mount Circle that is included with the Out-

Look Monitor and attach the OutLook Monitor to the Pillar Pod Circle

by running the OutLook wiring harness through the rectangular hole

in the circle and snap-

ping the back onto the

OutLook.

2. Follow the instructions for installing the single Pillar Pod

mount that are included in the pillar mount package.

3. Run the OutLook wires down through the hole in the pillar

mount system and connect the OutLook to the other harnesses.

4. Finally slide the Pod Mount Circle with the OutLook attached

into the pillar

mount hole.