S-7000DD
4. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
21
4-4. Setting basic functions
If you turn on the power switch while pressing the thread trimming disable/F1 key, you can then make the following settings.
Setting item
Four columns
display
Initial value Reference item
Needle stop position
Updn
Needle down
stop
Refer to”4-4-1”.
Correction
Corr
None Refer to”4-4-2”.
Slow start
SLoW
None
Setting can be carried out by pressing the
slow start/F2 key.
Thread trimming disable
trdi
None
Setting can be carried out by pressing the
thread trimming/F1 key.
Thread wiping
WiP
Enabled Refer to”4-4-3”.
Needle tip illumination lamp brightness
adjustment
LAMP
Fully
illuminated
Refer to the Service Manual.
4-4-1. Changing the needle stop position
This sets whether the needle bar stops in the needle up stop position or the needle down stop position when the treadle is
returned to the neutral position and sewing stops.
1
Activating setting mode
(While pressing the thread trimming disable/F1 key, turn on the
power switch.)
2
Setting the needle up stop and needle down stop positions
・ When the D key is pressed, the “UP”
display will appear.
・ When the C key is pressed, the “dn”
display will appear.
… Needle up stop
… Needle down stop
NOTE:
If the SEL key (1) is pressed once more,
the ABCD indicator will switch off and the
display will return to the setting item.
3
The setting will be stored and the display will
return to the setting item.
4
Setting mode will be exited and normal
operation will be possible.
(Setting item)
0517D
(Setting value)
0518
D
(Setting item)
0519D
0520D
