-27-
Revision 4/F3591 © Moffat Ltd, August 2004
1) Remove the right hand side panel (refer
6.2.4).
2) Remove the two screws securing the
microswitch bracket to the insulation
panel.
6.3.17 DOOR MICROSWITCH
Figure 6.3.25
1) Ensure water supply is turned off.
2) Remove the water injection nozzle from
inside the oven (refer 6.3.19).
3) Remove the water solenoid access panel
at the rear of the oven (4 screws).
6.3.15 WATER SOLENOID VALVE
1) Remove water solenoid (refer 6.3.20).
2) Remove the two screws securing the
bracket to the solenoid.
6.3.16 WATER SOLENOID CLEANING
3) Remove the valve assembly.
4) Clean the valve assembly, removing all
dirt and grime from the valve seat.
5) Reassemble the valve assembly and
solenoid.
Figure 6.3.23
Figure 6.3.24
Two Screws
Figure 6.3.20
4) Remove the wires from the solenoid, and
disconnect the mains water connection.
5) Remove the two screws securing the
solenoid bracket to the oven rear, and
remove the valve assembly.
Figure 6.3.21
6) On a suitable work surface, remove the
brass piping connections (½” spanner)
and two screws (on bracket) and extract
the solenoid.
7) Secure new solenoid with screws and
reassemble. Check that flow direction as
marked on valve is correct.
Brass
Connections
Two
Screws
Figure 6.3.22
Water
solenoid
access panel
