
User Guide P. 5
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured
by your installer and if button Ι is programmed as LOCK or UNLOCK button.
In an emergency situation, you can activate panic mode using the
Ι button. This will:
• shut down the engine,
• unlock the doors (with the Ι button)
• or lock the doors (with the Ι button),
• disarm the Starter Kill and
• activate the horn for 25 sec.
Note: See the description of the starter kill option later in this Guide.
To activate panic mode:
• Press and hold the Ι, button for approximately 3 sec. until the sound signal starts and
the parking lights flash: this will unlock the doors before the sound signal starts.
• Or press and hold the Ι, button for approximately 3 seconds until the sound signal
starts and the parking lights flash: this will lock the doors before the sound signal
starts.
Panic Mode will automatically shut down after 25 sec.
Note: To stop panic mode before the end of its delay, press the
Ι button until the sound
signal stops.
Cold Weather Mode
When Cold Weather Mode is active, the engine starts every 2 hours and runs for 3 minutes
(or for 8 or 20 minutes with Diesel engines); the routine goes on for a period of 24 hours.
To enter Cold Weather Mode:
• With the vehicle already in Ready Mode, press and hold the ΙΙ button until the
parking lights flash 3 times.
To exit Cold Weather Mode, do any one of the following:
• Open the hood.
• Start the engine using the remote control.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press and hold button ΙΙ for 3 seconds
(until the parking Lights flash once)
• Set the vehicle to Valet Mode.
Advanced Features: Installation-programmable options
The system was designed with flexibility and OEM integration in mind. With its programmable
options, this unit can control nearly any electrical system in your vehicle.
Note: The programming of these features should be left to a professional. Changing any
one of the settings may adversely affect the operation the Module.
Arming the Starter Kill
Note: Can only be activated if button Ι is programmed as
LOCK or UNLOCK button.
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm
automatically) or in Passive Mode (will arm automatically).
• To disarm the Starter Kill in Active or Passive Mode, press button Ι on the transmitter. The
parking lights will flash twice. (If Remote Door Locks were installed, this will also unlock
the doors.) In Passive Mode, the system will automatically rearm 1 or 3 minutes after the
doors were unlocked.