7
Installing the Lights
MAKE CERTAIN THAT THE BENCH GRINDER IS TURNED OFF AND UNPLUGGED
Locate the 2 15 watt light bulbs (included) and install them into the sockets at the end of
each flexible light arm. Turn bulb clockwise until it is secure.
Changing Accessories
MAKE CERTAIN THAT THE BENCH GRINDER IS TURNED OFF AND UNPLUGGED
USE ONLY GRINDING WHEELS THAT MEASURE 6 INCHES IN DIAMETER. THIS
TOOL HAS 1/2 INCH ARBORS ON BOTH SIDES.
Follow the steps presented below to remove and replace any accessory.
1. Raise the eye shield up, out of the way.
2. Loosen and pull the tool rest out as far as possible. Do not remove it.
3. Remove the screws from the side of the wheel cover and remove cover.
OPERATION
ALWAYS WEAR EYE PROTECTION WHEN USING THE GRINDER.
Keep a steady, moderate pressure on the work piece and keep it moving at an even pace
for smooth grinding. Pressing too hard overheats the motor and prematurely wears down
the grinding wheels, so take your time. Note the original bevel angle on the item to be
sharpened and try to maintain this shape. The grinding wheel should rotate into the object
being sharpened. Keep a tray filled with water and dip your work into it regularly to prevent
overheating. Overheating can weaken metals.
SCISSORS
If possible, take the scissors apart to make the sharpening operation easier and safer.
