6
ASSEMBLY INSTRUCTIONS
Your Bench Grinder comes with two grinding wheels and a package of loose parts which
include the following:
2 Tool Rests 4 Bolts
2 Mounting Brackets 4 Large Flat Washers
2 Eye shields 4 Medium Flat Washers
2 Spark Guards 4 Screws
2 Light Bulbs 4 Nuts
2 Knobs 4 Large Lock Washers
2 Internal Tooth Lock Washers 4 Small Lock Washers
4 Small Flat Washers
Installing Tool Rests
MAKE CERTAIN THAT THE BENCH GRINDER IS TURNED OFF AND UNPLUGGED
Remove the tool rests from top portion of the polyfoam carton liner and install them to the
wheel guards as shown in Figure1.Use the bolts and washers you removed from the bag
to secure them in place, as shown in the figure.
NOTE: There is a left and right tool rest. Refer to Figure 1 to ensure that you install them
correctly. When in actual use, the tool rests should be adjusted to within 1/8” (3.2mm) of
the grinding wheel or other accessory being used.
Installing Spark Guards and Eye Shields
MAKE CERTAIN THAT THE BENCH GRINDER IS TURNED OFF AND UNPLUGGED
The eye shields are packed in the plastic bag shipped with your grinder.
Carefully examine Figure 2 for assembly of eye shields and spark guards. You can align
up one eye shield, mounting bracket, one spark guard, two screws and two hex nuts.
