70-EN
You can make a telephone call by using voice operation.
• Connect your smartphone to the unit via Bluetooth, then set to
“Hands-free” or “Both”. (Page 62)
1
Press and hold the (PHONE) button for at least
3 seconds.
The Voice Dial mode screen is activated.
2
Say the telephone number* or name* you want to
call, into the microphone.
* The number and name depend on the voice dial information stored in
the smartphone.
3
To finish the Voice Dial mode, touch [ ] or press
and hold the (PHONE) button for at least 3
seconds.
• You can perform this operation only when a voice dial compatible
smartphone is connected.
• The Voice Dial function performance depends on the recognition
range of the smartphone and mounting location of the microphone.
Note when the microphone is mounted.
• Voice dial operation depends on the function being available on the
smartphone. For details, refer to the owner’s manual of the
smartphone.
• Depending on the smartphone, the Voice Dial operation may finish
automatically.
Adjusting the volume
Adjust the speaker/microphone volume in Voice Dial mode. Perform the
same procedure to adjust the speaker/microphone volume of Hands-
Free Phone.
Touch [ ] or [ ] of .
Adjust the speaker volume.
Touch [ ] or [ ] of .
Adjust the microphone volume.
Stopping input to the microphone
If the surrounding sound (road noise, etc.) is loud, you may wish to cut
input to the microphone for 3 seconds.
Touch [ ].
Operations During a Conversation
Display example
Name and phone number
Conversation time
You can adjust the transmit volume and receive volume respectively.
Touch [] or [] for “Vol.”.
You can adjust the volume in 11 levels.
Touch [] to turn down the volume. Touch [] to turn up the
volume.
The voice output for calls is switchable between car speakers and the
mobile phone speaker.
Touch [].
• Depending on the mobile phone, this operation may not be possible.
Transmits a DTMF (Touch-Tone) during a call.
1
Touch [TONE].
The number input screen appears.
2
Input number.
• You can transmit a Touch-Tone signal during a call.
• Touching and holding “0” initiates “+” tone transmission.
Voice Dial Function
Adjusting the Speech Volume
:Outgoing volume
:Incoming volume
Changing the Voice Output
DTMF (Touch-Tone) Function
