New Parameters Added in 2.0.2
RN-001029-00, Release 2.0.2, Rev 02 27
SIP IP Phone Models 53i, 55i, 57i, 57i CT Release Notes
New Parameters Added in 2.0.2
These parameters were described in the previous section (“Enhancements/
Changes in 2.0.2, Build 1040”) and are repeated here for your convenience. These
parameters have been incorporated into the
Release 2.0.2 Administrator’s Guide.
Incoming Call Interrupts Dialing
Parameter –
incoming call interrupts
dialing
Incoming Call Interrupts
Dialing
(in Web UI)
Aastra Web UI: Basic Settings->Preferences->General
Configuration Files aastra.cfg, <mac>.cfg
Description Enable or disables how the phone handles incoming calls while the phone
is dialing out.
When you enable this parameter (1 = true), an incoming call interrupts the
outgoing call during dialing and allows the phone to ring for the user to
answer the incoming call.
When you disable this parameter (0 = fales), which is the default, the
phone does not interrupt the outgoing call during dialing and instead rings
the incoming call on another free line (or sends busy signal if all
remaining lines are busy). You have a choice to ignore the incoming call,
or answer the incoming call on another line. If you choose to answer the
incoming call, you can answer the call, finish the call, and then hang up.
You can still go back to the original outgoing call and finish dialing out.
On the 5i Series Phones:
If you disable this parameter (0=false), and the phone receives an
incoming call while you are dialing an outgoing call, you can pick up the
call and perform transfer or conference as required.
Note: After enabling or disabling this feature, it takes affect on the phone
immediately.
Format Boolean
Default Value 0 (false)
Range 0 (false)
1 (true)
Example incoming call interrupts dialing: 1
