Enhancements/Changes in 2.0.2, Build 1040
RN-001029-00, Release 2.0.2, Rev 02 21
SIP IP Phone Models 53i, 55i, 57i, 57i CT Release Notes
ENH06058 XML Softkey LED Control Feature
A feature has been added to the IP phones that allows an Administrator to control
the behavior of XML softkey LEDs. You use the AastraIPPhoneExecute object to
implement this feature.
Note: This LED feature is applicable to XML softkeys only (softkeys (top or bottom),
programmable keys, and expansion module softkeys). The softkey must be
configured for XML before you enable this feature.
The following table describes the behaviors you can assign to XML softkeys and the
attribute you enter in the AastraIPPhoneExecute script.
The command for LED control is sent using the XML http post from one of the XML
push server lists. The following example shows an XML LED command in an
AastraIPPhoneExecute script.
<AastraIPPhoneExecute>
<ExecuteItem URI=”Led: topsoftkey20=on”/>
<ExecuteItem URI=”Led: softkey1=off”/>
<ExecuteItem URI=”Led: prgkey2=fastflash”/>
<ExecuteItem URI=”Led: expmod2 key20=slowflash”/>
</AastraIPPhoneExecute>
Notes:
1. Using the Aastra Web UI, you must set the XML push server list from where the
XML http post is being sent.
2. The LED states specified in the AastraIPPhoneExecute script are not saved
after a reboot.
Issue Number Description of Feature/Enhancement
LED Behavior XML Attribute
on URI = “Led: <softkey type>= on”/
off URI = “Led: <softkey type>=off”/
fastFlash URI = “Led: <softkey type>=fastflash”/
slowFlash URI = “Led: <softkey type>=slowflash”/
