184 APPENDIX A: UPGRADING VCX SERVER SOFTWARE FROM V7.0 TO V7.1
feature's operation. Typically the Central Servers are at
one of the regional sites.
Is this a Central Server for Global Voicemail? [N] :
If this server has been configured as a Global Voicemail Central Server,
enter y and go to step 5.
If you answer
n to indicate that this is not a Central Server, you will be
prompted to enter the Central Server IP address.
5 After completing the UPS Monitoring and Global Voicemail Integration
prompts, the server reboots. When the reboot process has been
completed, the system starts VCX 7.1.x services.
6 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
Upgrading the
Secondary IP
Telephony Server
Follow the steps in this section to upgrade the secondary IP Telephony
server.
1 To start the upgrade process, enter these commands on the secondary IP
Telephony server:
cd /opt/installtemp
tar xvf vcx-softswitch-7.1.xc.tar
cd upgrade-7.1.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.xc is now available -------------------
