Filter
Top Products
Z-Wave Series Programming Guide 8
CHAPTER 2
SHD1110 Programming
2.1 Z-Wave Groups (Association Command Class Version 2)
On the Z-Wave Controller, you can set the SHD1110 to send reports of itself (including power,
temperature, humidity, and battery status) to associated nodes of Grouping 1 or control
associated Z-Wave devices of Grouping 2. Grouping 1 supports one node and Grouping 2 supports
up to three nodes.
2.1.1 Grouping 1
Grouping 1 includes the following commands: POWER_APPLIED, SENSOR_MULTILEVEL
_REPORT, ALARM_REPORT and BATTERY_REPORT_COMMAND.
2.1.1.1 POWER_APPLIED command
When power is applied to the SHD1110, the ALARM_REPORT command will be sent to Grouping 1
to inform that the SHD1110 is powered up.
2.1.1.2 MULTILEVEL_SENSOR_REPORT
The SHD1110 automatically sends out SENSOR_MULTILEVEL_REPORT, containing its current
temperature and humidity, to Grouping 1. Refer to the Z-Wave’s Configuration section on page 10
for settings of auto report configuration.
Humidity
The following parameters are used in this example:
Sensor Value 1 = 0x23
Humidity Value = Sensor Value = 35 (%)
ALARM_REPORT Command
[Command Class Alarm, Alarm Type = 0x02, Alarm Level = 0x01]
SENSOR_MULTILEVEL_REPORT
[Command Class Sensor Multilevel, Sensor Multilevel Report, Sensor Type = 0 x
05 (Relative Humidity), Precision+Scale+Size = 0 x 01, Sensor Value 1 = 20-
90%]