Filter
Top Products
Chapter 2 SHD1110 Programming
Z-Wave Series Programming Guide
10
When the SHD1110 is triggered, it will send out BASIC_SET_COMMAND to the nodes of Grouping
2.
Refer to the Z-Wave’s Configuration section to configuration parameter 1 for the setting of basic set
command.
2.1.3 Z-Wave’s Configuration
The table below lists the configuration parameters and the value range for users to set up the
SHD1110.
[Command Class Basic, Basic Set, Value = (255)0xFF]
send trigger-ON command
[Command Class Basic, Basic Set, Value = 0(0x00)]
send trigger-OFF command
Table 1 Z-Wave Configuration Table
PARAMETER FUNCTION SIZE (BYTE) VALUE UNIT
FACTORY
DEFAULT
DESCRIPTION
1Basic Set
Level
10~99% of
Brightness
(Dimmer
Level)
99 / 99 Set basic set value to
be on (or Dim Level)
/off.
0: Disable
2Temperature
Trigger-ON
Value
1 -20~50
or
99
Degree 30 / 99 Set temp.trigger-ON
value to be _ degree.
99: Clear Temp.
trigger-ON value
3Temperature
Trigger-OFF
Value
1-20~50
or
99
Degree 20 / 99 Set temp.trigger-OFF
value to be _ degree.
99: Clear Temp.
trigger-OFF value
4Humidity
Trigger-ON
Value
1 20~90
or
99
% 50 / 99 Set humid. trigger-
ON value to be _%.
99: Clear Humid.
trigger-ON value
5Humidity
Triger-OFF
Value
1 20~90
or
99
% 40 / 99 Set humid. trigger-
OFF value to be _%.
99: Clear Humid.
trigger-OFF value
6Auto Report
(Time
Interval)
2 1~1439
or
99
Minute 0 / 0 Set auto report time
interval to be _ mins.
0: Disable auto
report