Filter
Top Products
Page 2 Zenithip Tudor - Installation & Operating Instructions - 81333 - May 2003
#
Read These Warnings First
Tapware
# Quick Installation Guide
Please read all installation requirements, installation procedures and
precautions before installing any Zenith Tudor water heater.
Never attempt to install any Zenith Tudor water heater without reading all of the
applicable instructions.
Zenith Tudor water heaters are open outlet (vented) water heaters and must not
be installed in the same way as mains pressure type water heaters.
The outlet from any Zenith Tudor water heater must be connected directly to an
outlet spout on the sink and must not be obstructed by a tap or valve or in any
other way.
The water flow is controlled by a cold water tap connected before the water
heater. Cold water pushes hot water out of the tank when the cold water tap is
turned ON. Any such cold water tap should be labelled HOT.
This water heater must not be connected to more than one outlet.
All plumbing connections must be made in accordance with AS3500.
The heater is intended only for indoor use and should never be installed
outdoors or be exposed to the elements of nature.
Over-sink and under-sink models are NOT interchangeable.
Children should be supervised to ensure they do not play with the heater.
The heater is unsuited for use by children or infirm people without supervision.
If the power supply cord is damaged it must be replaced by a Zenith Service
Provider or a qualified electrician.
Do not remove the cover of the heater under any circumstances without first
isolating the heater from the power supply.
Outlet temperature should never be set to less than 60°C without due regard to
regulations governing the storage temperature of hot water.
!
Step One
Install approved vented tapware
see page 3
Step Two
Position heater <1000 mm from tap
see page 4
Step Three
Fasten heater to wall
see page 4
Step Four
Connecting
see page 4
Step Five
Commissioning
see page 4
before turning power on
Tudor Heater
Isolation valve
Cold Water Supply
Flow Restrictor
Page 2 Zenith Tudor - Installation & Operating Instructions - 81333 - July - 2004