Filter
Top Products
Operation 11
MAN0661 (8/10/2007)
Figure 3. Back of Attachment - Slot Locations
ADJUSTMENT
Before leaving operator's seat, lower lift arms
and put attachment on the ground. Engage brake,
stop engine, remove key, and remove seat belt.
Check Brush Pattern
A properly adjusted brush offers the best sweeping
performance. To check the brush pattern, move the
pick-up broom to a dusty, flat surface. Set the skid
steer parking brake and leave the engine running.
Start the broom at a low speed; then, lower it so the
bristle tips touch the ground. Run the broom in a sta-
tionary position for ten seconds.
Raise the broom and back away. Switch off the engine
and remove the key. The brush pattern left in the dust
should be two to four inches wide, running the length of
the brush. See Figure 4.
Figure 4. Brush Pattern
If the brush pattern is not two to four inches wide,
adjust brush pattern accordingly.
Figure 5. Adjustment Bolt and Brush Pattern