Windsor Saber Blade 12 Vacuum Cleaner User Manual


 
10 English
Warning
Risk of damage. Do not wash down the
appliance with water and do not use ag-
gressive detergents.
Î Empty the recovery tank.
Î Clean the seals between the recov-
ery tank and the appliance.
Î Empty the solution tank.
Î Rinse the appliance: Fill the solution
tank with water (without detergent)
and let the appliance run for one
minute with the brush water supply
turned on.
Î Empty the solution tank.
Î Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
Î Clean the squeegee, check for wear
and replace if required (see "Mainte-
nance tasks").
Î Check the brush for wear and re-
place if required (see "Maintenance
tasks").
Î Have the prescribed safety inspec-
tion carried out by an electrician.
Note
The squeegee is attached to the appli-
ance with snaps and can simply be
pulled off.
Î Move the squeegee lift pedal to posi-
tion „suction off“ (Fig. 3 - position "1/
ON", see inside front cover).
Î Remove the solution tank from the
appliance.
Î Remove the recovery tank.
Î Lay the device down on the back-
side.
Î Pull off the squeegee downwards.
Î Insert the new squeegee and lock
them into place.
Î Remove the solution tank from the
appliance.
Î Remove the recovery tank.
Î Lay the device down on the back-
side.
Î Press the release button for the
brush and swivel the brush toward
the bottom and pull it off the driver.
Î Place the new brush on the driver
and lock into place on the opposite
side.
In case of danger of frost:
Î Empty the solution and recovery
tank.
Î Store the appliance in a frost-pro-
tected room.
ƽ Danger
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
Warning
Risk of damage to the appliance on ac-
count of water leakage. Empty the
waste water reservoir and the fresh wa-
ter reservoir prior to performing mainte-
nance on the appliance.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.
Maintenance schedule
After the work
Yearly
Maintenance Works
Replace the squeegee.
Replacing the brush
Frost protection
Faults