Filter
Top Products
2.
After installing new belt check for clear
-
ance between traverse pulley and brush
BRUSH ANGLE
ADJUSTMENT
CAUTION:
Operating the machine with
excessive pressure on the squeegee will
cause abnormal wear on the squeegee
blades.
BRUSH DRIVE BELT
1.
Remove traverse drive belt by rolling belt
off pulley.
2.
Loosen belt tension adjusting screw and
remove brush drive belt. After readjust
-
ing belt tension, make sure lock nut on
adjusting screw Is tight.
‘\
TRAVERSE DRIVE BELT
1.
With operating handle in neutral position,
roll belt off pulley. Replace as required.
drive belt. The pulley should not be in
contact
with the belt when the traverse
handle is in the neutral position.
- --
-
-
-
~ ~
1.
Start
the
brush
motor
and
lower
the
brush slowly to the floor. When the rear
of the brush
“A”
touches the floor, the
To
adjust clearance:
A.
Remove left side panel.
front of the brush
“8”
should be about
3/16”
from the floor.
B.
Loosen lock nuts on link rod. Adjust
2.
BY releasing the foot lift pedal the
bracket on link rod
so
pulley does not Springs will allow the brush to rest com
-
contact belt. Retighten lock nuts on pletely on the floor.
link rod.
A.
If
the brush vibrates while in opera-
tlon
Increase dirtanu
“B”.
B.
If
the machine pulls to the left during
operation
decrease dlrtanu
“B”.
3.
The springs
(C)
should be adjusted
so
as
to maintain the distances
as
shown.
4.
To
change brush inclination, IOOSen nut
(D)
and turn tie
-
rod
(E)
until the correct
angle
Is reached.
A