Windsor GH3 Vacuum Cleaner User Manual


 
SAFETY
GROUTHOG 86038000 05/17/07
3
INSPECTION
Please carefully unpack and inspect your
GROUTHOG for shipping damage. Each unit is
operated and thorougly inspected before shipment,
and any damaged is the responsibliltiy of the
delivering carrier who should be notified immediately.
ELECTRICAL
The Grouthog is designed to operate on a standard
15 amp, 115 volt, 60 hz, AC household current.
Check that the voltage shown on the serial number
plate is suitable for the supply available. Voltages
below 105 volts or above 125 volts could cause
damage to the motor.
* 230/250 volt 50 hz models are available.
NOTE: The GROUTHOG is equipped with a safety
relay switching system that prevents accidental motor
start-up. If the power cord is unplugged during use,
the machine will not start when reconnected, until the
the ‘ON’ switch is depressed.
GROUNDING INSTRUCTIONS
This applicance must be grounded. If it should
malfunction or break down, grounding provides a
path of least resistance for electric current to reduce
the risk of electric shock. This appliance is equipped
with a cord having an equipment-grounding
conductor and grounding plug. The plug must be
inserted into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
Improper connection of
the equipment-
grounding conductor can result in a risk of
electric shock. Check with a qualified electrician
or service person if you are in doubt as to
whether the outlet is properly grounded. Do not
modify the plug provided with the appliance. If it
will not fit the outlet, have a proper outlet
installed by a qualified electrician.
This appliance is for use on a nominal 120-volt
circuit, and has a grounded plug that looks like the
plug in “Fig. A” below. A temporary adaptor that
looks like the adaptor in “Fig. C” below may be used
to connect this plug to a 2-pole receptacle as shown
in “Fig. B” below, if properly grounded outlet is not
available. The temporay adaptor should be used
only until a properly grounded outlet (Fig. A) can be
installed by a qualified electrician. The green colored
rigid ear, lug, or the like extending from the adaptor
must be connected to a permanent ground such as a
properly grounded outlet box cover. Whenever the
adaptor is used, it must be held in place by a metal
screw.
To avoid electrical
shock, use indoors only.
EXTENSION CORDS
If an extension cord is used, the wire size must be at
least one size larger than the power cord on the
machine and should be limited to 50 feet in length.
Extension cord must be three wire grounded. The
machine is equipped with a 18/3-40’ power cord.
EQUIPMENT SETUP
NOTE: Attach stain relief/cord retainer to the power
cord.
1. Make a loop in power cord
approximately 18” from main
housing.
2. Slide cord loop through slot in
retainer arm. Pull slack cord
back though slot to secure.