Filter
Top Products
OPERATIONS
D100 86038620 05/21/07
3-
2
CARPET INSPECTION:
Determine precisely what areas you are going
to clean. Note problem areas in the carpet or
tack strip. Look for loose carpet, heavily
damaged areas, discolored stains, or grease
spots that will require prespotting. Note the
carpet type. Check the availability of hot water,
drains, and suitable electrical outlets. If the
carpet is loose or worn, have it repaired before
attempting to clean it.
Plan the cleaning route, work from the most
remote area towards the exit. Try not to travel
over the cleaned areas when getting fresh
water or dumping old. Furniture should be
moved out away from the walls before cleaning.
If furniture is moved back in place before carpet
is completely dry, place plastic or foil protectors
under the legs to prevent possible carpet
staining. When possible use a Windblower
(AM3) and open all windows and doors to
speed carpet drying.
ACCESSORIES:
The D100 can be used with the following
Windsor equipment: Deluxe Hand Tool
(86000020 – PRV NO. HT), Pile Jogger
(86041760 – PRVNO. PJ2A), Standard Floor
Wands(SFW, 86000610 – PRV NO. 89227,
86000600 PRV NO. 89226, & Wind Blower
carpet dryer(AM3). Contact an authorized
Windsor dealer for assistance in choosing the
right equipment .
GENERAL INFORMATION:
On heavily soiled carpets, or on areas of
high foot traffic, it may be necessary to use a
prespray or traffic lane cleaner applied with a
Pro-Spray. Do not add presprays to the
machine's solution tank. If a spotter is used,
follow the manufacturer's instructions exactly as
printed on the label. Remove the spotter with
the floor tool when done, spotter left in the
carpet may bleach or brown it permanently.
As the carpet is being cleaned, check to see
if there is foam building up in the recovery
bucket. Add a little defoaming compound to
the recovery tank but never to the solution tank.
For infrequent use or long periods of
storage, flush the system with a neutralizing
solution of 1 quart white vinegar mixed with 2
gallons hot water. Flush the system with clean
hot water after neutralizing.
For hose fitting lubrication, use a light
silicone lubricant which will not damage o-rings.
PROTECT THIS MACHINE FROM
FREEZING.
EQUIPMENT SET-UP:
1.) Plug power cable from machine into
properly grounded wall outlet.
2.) Turn vacuum motor switch on and off to
make sure there is electrical power at machine.
3.) Connect vac hose to machine. Slide the
swivel cuff over the outlet on the tank.
4.) Connect the hose set to your machine and
wand. Pull back the knurled collar on the quick
disconnect coupler and push onto the
connection on the chassis. To avoid leaks,
check to be sure a positive connection was
made.
5.) Using a clean container, fill the solution
tank with clean, hot water. Mix in a non-
foaming cleaning concentrate for use in hot
water extraction machines following the
manufacturer's instructions, as printed on the
container. When using a powder cleaner,
premix with hot water in a clean container
before adding to the solution tank.
6.) Turn pump and vacuum switch to the on
position.
7.) Start cleaning.