Filter
Top Products
MAINTENANCE-BAG REPLACEMENT
86317500 CHARIOT SCRUBBER 11/15/08
4-22
REMOVING OR REPLACING BAG
1. Disconnect batteries and make sure parking brake
is not overridden.
2. Remove Dome and set aside.
3. Drain all solution from both sides of the bag and
rinse well.
4. Remove float cage, loosen screw on elbow and
remove elbow. (You can remove the bag by only
removing the float cage and sliding the bag
opening over the elbows.)
5. Remove threaded mandrel from the bottom of the
bag. Turn counterclockwise, remove by grabbing
the attached handle. The mandrel washer should
come off with the mandrel.
6. Lift the bag assembly out of the tank. The dome
gasket, plastic collar, and metal frame can all be
removed as one assembly. The bag can be
cleaned as an assembly or further disassembled.
7. To replace with a new bag remove the four screws
that go through the collar and into the frame.
Feed the frame through the loops at the top of the
bag.
8. Re-assemble frame, collar and bag if they
were disassembled.
9. Place bag assembly into tank.
10. Align bag drain hole with fitting in bottom of
tank and thread in mandrel with washer
attached. Turn clockwise to tighten. Tighten
only by hand, do use a tool. Ensure mandrel is
tight, the bag should be unable to move or
spin around the mandrel.
11. Seat the collar, gasket, frame assembly to the
tank rim opening. At the same time slide the
vacuum collar opening over the float cage
elbow assembly.
12. Replace the rest of the elbow and float cage
assembly with its mounting screw, if it was
removed.
13. Install dome and connect squeegee hose.