Filter
Top Products
MACHINE OPERATION
86317500 CHARIOT SCRUBBER 11/15/08
3-15
TO BEGIN SCRUBBING
When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
Flammable liquids and/or reactive metals can
cause explosions or fire! Do not pick up.
1. Stand on the operator platform. Throttle pedal
must be in neutral position.
2. Turn machine power on.
3. Press the Drive Reset / Directional Control
Switch, selecting the desired travel direction.
4. Position the function control knob to the desired
operation. The brush motors will start, the scrub
deck will lower, the solution will begin to flow,
the squeegee will lower to the floor and the
vacuum motors will start.
5. Drive machine forward to begin scrubbing.
NOTE: Shut machine off immediately if water or
foam is expelled from the machine.
NOTE: Solution flow is automatically shut off when
brush motors stop. When brush motors are
activated, flow automatically resumes.
PRIMING PUMP
If the solution system has gone dry or has been
unused for a period of time, it may be necessary to
follow the pump priming procedure.
1. Fill solution tank.
2. Loosen, but do not completely remove the
strainer bowl. Solution should flow out of the
strainer. If it does not, check the strainer screen
inside the solution tank. Insure it is clear of
debris. Tighten the strainer bowl.
3. Disconnect the squeegee hose from the
recovery dome.
4. Begin normal scrubbing. Solution flow should
begin within 2 minutes.
5. Connect squeegee hose to recovery dome.