Mode button
Dehumidifying mode
Mode button
Caution:
In cooling and dehumidifying modes, if the compressor cycle is interrupted (due to unplugging, power failure,
etc.), a protection circuit is automatically activated, preventing the compressor from operating. This is no
cause for alarm, but the protection circuit may need 3-5 minutes to deactivate. Do not attempt to restart the
compressor until you hear that the protection circuit is no longer activated.
Dehumidifying mode
In dehumidifying mode, the compressor will automatically run at regular intervals of 10 minutes ON and 4 minutes OFF.
In this mode, the temperature and the fan speed cannot be adjusted. The fan will automatically run at low speed.
1. Press the ON/OFF button on the remote control or on the unit’s control panel to start the air conditioner.
2. Press the MODE button repeatedly until the dehumidifying mode icon ( ) or ( ) is displayed in the upper left corner
of the remote control and at the top of the unit’s control panel display.
Note:
The exhaust and intake hoses are not required during dehumidifying mode only. (Do not forget to put the drain tube in a
container or directly in a drain).
Owner’s manual _11
11. DEHUMIDIFYING MODE