Williams M00045-V01 Air Conditioner User Manual


 
Mode button
Mode
button
Cooling mode icon
Cool mode icon
In cooling mode, you can use the remote control and the unit’s
control panel to adjust the following :
- temperature
- fan speed (Low, med, high, auto)
- airflow direction
1. Press the ON/OFF button on the remote control or on the unit’s
control panel to start the air conditioner.
2. Press the MODE button repeatedly until the cooling mode icon
( ) is displayed in the upper left corner of the remote control and
at the top of the unit’s control panel display.
3. Press the fan speed adjustment button ( ) and select the desired
speed (low, med, high, auto).
4. To adjust the temperature, press the WARMER/COOLER buttons
until the targeted temperature is displayed. The available temperature
range is between 64 °F and 87 °F.
Each time you press a WARMER/COOLER button,
the temperature is adjusted by 1 °F.
5. The air conditioner starts cooling, provided that the room
temperature is higher than the selected target temperature.
Note:
- If the room temperature is lower than 64 °F, the air conditioner will not
allow the compressor to operate in cooling mode.
- If the room temperature is too low and the room humidity is too
high, frost or ice can form on the surface of the evaporator.
However, the air conditioner is pre-adjusted to protect itself
against it. Whenever the evaporator temperature drops below
32 °F, the fan will run at high speed until the evaporator temperature
increases to 45 °F.
Caution:
Set a reasonable temperature to avoid discomfort
from overcooling.
Fan speed
adjustment
button
Temperature
adjustment
buttons
Fan speed
adjustment
button
Temperature
adjustment
buttons
Owner’s manual _10
10. COOLING MODE