White Rodgers 50M56U-843 Thermostat User Manual


  Open as PDF
of 8
 
PAGE 3 CONTAINS WIRING HARNESS AND
BLOWER CONNECTION INSTRUCTIONS FOR
ALL APPLICATIONS AND IMPORTANT OEM
REPLACEMENT INSTRUCTION FOR:
● TRANE / AMERICAN STANDARD
● RHEEM / RUUD
● BRYANT / CARRIER / DAY & NIGHT / PAYNE
INSTALLER MUST READ
www.white-rodgers.com
www.emersonclimate.com
50M56U-843
Universal Single Stage
HSI Integrated Furnace Control Kit
INSTALLATION INSTRUCTIONS
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS
CAREFULLY BEFORE INSTALLING OR OPERATING
THIS CONTROL COULD CAUSE PERSONAL INJURY
AND/OR PROPERTY DAMAGE.
DESCRIPTION
The 50M56U-843 kit is a Universal Single Stage HSI Integrated
Furnace Control that employs a microprocessor to continually
monitor, analyze, and control the proper operation of the gas
burner, inducer, and fan.
The kit contains:
• 50M56-843IgnitionControlModule
• 21D64-2IgnitorKit
• SetofInterconnectHarnesses
Installation should be done by a qualified heating and air
conditioning contractor or licensed electrician.
If in doubt about whether your wiring is millivolt, line, or low
voltage, have it inspected by a qualified heating and air
conditioning contractor or licensed electrician.
Donotexceedthespecicationratings.
All wiring must conform to local and national electrical codes
and ordinances.
This control is a precision instrument, and should be handled
carefully. Rough handling or distorting components could
cause the control to malfunction.
Following installation or replacement, follow manufacturer’s
recommended installation/service instructions to ensure
proper operation.
PRECAUTIONS
PART NO. 37-7042C
Replaces37-7042B
1103
Do not short out terminals on gas valve or primary
control. Short or incorrect wiring may damage the
thermostat.
CAUTION
!
Failure to comply with the following warnings could result
in personal injury or property damage.
FIRE HAZARD
• Donotexceedthespeciedvoltage.
• Replaceexistingcontrolwithexactmodeland
dash number.
• Protectthecontrolfromdirectcontactwithwater
(dripping, spraying, rain, etc.).
• Ifthecontrolhasbeenindirectcontactwith
water, replace the control.
• Labelallwiresbeforedisconnectionwhen
servicing controls. Wiring errors can cause
improper and dangerous operation.
• Routeandsecurewiringawayfromame.
SHOCK HAZARD
• Disconnectelectricpowerbeforeservicing.
• Ensureproperearthgroundingofappliance.
• Ensureproperconnectionoflineneutralandline
hot wires.
EXPLOSION HAZARD
• Shutoffmaingastoapplianceuntilinstallation
is complete.
WARNING
!
CONTENTS
Description ...................................................................1
Precautions ..................................................................1
Specifications ..............................................................2
Installation ...................................................................2
Mounting & Wiring
Operation ..................................................................... 6
Troubleshooting ........................................................... 8
50M56-843
21D64-2
next