Filter
Top Products
INSTALLATION (CONT.)
2
In this regard, do not locate the bulb too close to the heating
element.
2. Care should be taken not to damage the capillary tubing
between the switch and bulb of the control. Do not kink the
capillary.
3. Do not dent or bend the control bulb as this will change the
control calibration and cause the control to cycle at a tem-
perature lower than the dial setting.
4. The switch of the control may be mounted in any convenient
location provided that the ambient temperature surrounding
the switch does not exceed 150°F (66°C).
WIRING
All wiring should be done in accordance with local and national electrical codes and ordinances.
Follow any instructions provided by the equipment manufac-
turer.
The diagrams shown here represent typical wiring for these
controls.
SETTING
In most cases the equipment manufacturer has provided a dial
to indicate the setting of the control. For a warmer setting, turn
knob or shaft clockwise. For a cooler setting, turn knob or shaft
counterclockwise.
BLUE (LOAD)
BLACK (LINE)
L1
L2
240V
TYPE 2B62TYPE 2B61
L2
L1
LINE
LOAD
MAKE L1 “HOT”
ON 120V MODELS