Filter
Top Products
Entering Your Program
Follow these steps to enter the heating and cooling programs
you have selected.
Set Current Time and Day
1. Press SET TIME button once. The display will show the hour
only.
EXAMPLE:
PM
2. Press and hold either or until you reach the correct
hour and AM/PM designation (AM begins at midnight; PM
begins at noon).
3. Press SET TIME once. The display window will show the
minutes only.
EXAMPLE:
4. Press and hold either or until you reach the correct
minutes.
5. Press RUN PRGM once. The display will show the correct
time and room temperature alternately.
Enter Heating Program
1. If you want to change the display from Fahrenheit to Celsius
(or vice-versa), press SET TIME and HOLD TEMP at the
same time.
2. Move the SYSTEM switch to HEAT.
3. Press VIEW PRGM once. The currently programmed start
time for the 1st heating period and the currently pro-
grammed temperature will be displayed (flashing).
EXAMPLE:
AM
MO TU WE TH FR
This display window shows that for the 1st heating period,
the start time is 6:00 AM, and 68° is the programmed
temperature (this example reflects factory preprogramming).
4. Press or to change the displayed temperature to your
selected temperature for the 1st heating program period.
5. Press SET TIME once (the programmed time will flash).
Press
or until your selected time appears. The time
will change in 15 minute increments. Press SET TIME a
second time to return to the change temperature mode.
6. Press VIEW PRGM once. The currently programmed start
time and setpoint temperature for the 2nd heating program
period will appear.
7. Repeat steps 4 and 5 to select the start time and heating
temperature for the 2nd heating program period.
8. Repeat steps 4 through 6 for the 3rd and 4th heating program
periods. The heating programs are now complete.
9. When you have completed entering your heating program,
press RUN PRGM.
Enter Cooling Program
If the outside temperature is below 50°F, disconnect
power to the cooling system before programming.
Energizing the air conditioner compressor during
cold weather may cause personal injury or property
damage.
1. Move SYSTEM switch to COOL position.
2. Follow the procedure for entering your heating program,
using your selected cooling times and temperatures.
CHECK YOUR PROGRAMMING
Follow these steps to check your thermostat programming one
final time before beginning thermostat operation.
1. Move SYSTEM switch to HEAT position.
2. Press VIEW PRGM to view the 1st heating period time and
temperature. Each time you press VIEW PRGM, the next
heating period time and temperature will be displayed in
sequence (you may change any time or temperature during
this procedure).
3. Press RUN PRGM.
4. Move SYSTEM switch to COOL position.
5. Repeat step 2 to check cooling temperatures.
6. Press RUN PRGM to begin program operation.
YOUR THERMOSTAT IS NOW COMPLETELY PRO-
GRAMMED AND READY TO AUTOMATICALLY PROVIDE
MAXIMUM COMFORT AND EFFICIENCY!
CAUTION
!