Filter
Top Products
15
Efficiency Icon
In the state of California: You must turn the Salt
Efficiency Fea ture ON. This may initiate more
frequent recharges. However, it will operate at
4,000 grains per pound of salt or higher.
Customizing Features / Options
POWER OUTAGE MEMORY
If electrical power to the water softener is lost, “mem-
ory'' built into the timer circuitry will keep all settings
for up to six hours. While the power is out, the dis-
play is blank and the water softener will not regener-
ate. When electrical power is restored, the following
will occur:
Reset the present time only if the display is flashing.
The HARDNESS and RECHARGE TIME never
require resetting unless a change is desired. Even if
the clock is incorrect after a long power outage, the
softener operates as it should to keep your water soft.
However, regenerations may occur at the wrong time
of day until you reset the clock to the correct time of
day.
NOTE: If the water softener was regenerating when
power was lost, it will now finish the cycle.
WATER FLOW INDICATOR
Whenever the softener has water flowing from the
outlet port, the display will show water droplets scroll-
ing down the right hand side of the screen (See
Figure 24). The faster the water flow, the faster the
droplets will flash.
SALT EFFICIENCY
When this feature is ON, the water softener will oper-
ate at salt efficiencies of 4000 grains of hardness per
pound of salt or higher (May recharge more often
using smaller salt dosage and less water). The sof-
tener is shipped with this feature set OFF.
1. Press and hold the PROGRAM button until the
screen in Figure 25 is displayed. Once in this dis-
play, press the PROGRAM button once and one of
the two displays in Figure 26 is shown.
FIG. 24
Droplets indicate water
flow through softener
2. Press the r UP or s DOWN buttons to set ON or
OFF. When set to ON, the efficiency icon will be
displayed in the lower left hand corner of the nor-
mal run display.
FIG. 25
FIG. 26