Filter
Top Products
8
3. Measure wall sleeve depth. If sleeve is
more than 18" deep, remove condenser
baffle. Use the 2 screws from the condenser
baffle to attach the deep filler panel in place
of the condenser baffle.
4. Slide the air conditioner into the sleeve until
the condenser baffle (or deep filler panel, if
installed) contacts the exterior grille.
Continue installation with steps 8-11, page 9 ,
"Installing in a new sleeve."
Installing in a new sleeve
1. Remove the front and back covers. Save
these for future use to seal the sleeve if the
air conditioner is removed.
2. Remove the rear grille from the sleeve.
3. Brush out all debris from inside the sleeve,
making sure the inside is clean and that the
drain holes are completely open.
4. Loosen screws in the rear grille to about
1
⁄8".
Then, while holding on to the wire loop, tip
the grille and pass it through the rear
opening of the sleeve. The baffle contact
area should be on the left.
Installation Instructions
Continued
sleeve
back cover
(outdoor side)
front cover
(indoor side)
deep
filler
panel