Filter
Top Products
window
channel
mounting hole
filler
board
1
n
Hold air conditioner to prevent it from
falhng. Raise window sash. Place
side-
mounting slides into top mounting channel.
Extend mounting slides outward into window
channels. Pull air conditioner slightly forward
until
slides
are tight against window channels,
Mark hole locations
and
use a 3132” drill bit to
drill starter holes for
wood
screws. Use wood
screws to attach slides to
window
channels. Do
Vat tighten screws at this time. Lower window
<ash behind top mounting channel.
2
w Check that air conditioner
cabinet is tilted to the outside so that
water will run to the outside.
Place level on top of right side of air
conditioner. There should
be a
tilt to the
outside of approximately
l/2
bubble. Place
level on left side
and
check. If cabinet is
not
properly positioned, reposition or shim the
cabinet to provide the proper tilt.
Tighten filler board and side-mounting slide
screws.
wi
br
NOTE: Install
window-lock
bracket to prevent
air conditioner from falling out of window.
3
w Insert window rail seal behind top of
lower window sash and against glass of upper
window. Place window-lock bracket on top of
lower window
and
against the upper
window
sash. Use a
342”
drill bit to
drill a
starter hole
through the hole in the bracket. Attach window-
lock
bracket with
wood
screw. Seal small
openings around the window with gum-type
sealer.
4
n
Place bottom edge of front panel
on
clips and push down. Push panel into
cabinet
until panel snaps into place. Plug power
supply cord into grounded electrical outlet.
Congratulations!
You have successfully
installed your new air
conditioner. To get the most
efficient use from your new
air conditioner, read the
Use and Care Guide section
of this book.