Filter
Top Products
6
Window Installation
1. Using the tray back as a template, center in windowsill
against outside edge of stool.
2. Using the 2 inside screw holes in tray back, mark
screw locations on windowsill for mounting the
SMART-MOUNT
®
tray.
3. Remove tray back. Using these marks, drill ³⁄₃₂" pilot holes in
the windowsill approximately 1¹⁄₂" (3.8 cm) deep.
Assemble SMART-MOUNT
®
Tray
1. To assemble the tray frame, insert tab on tray back into slot
on tray side. Check to see that the tab is engaged and the
2 pieces are aligned. Insert 2 - #8 - 18 x ¹⁄₄" hex-head screws
to secure.
2. Repeat with other tray side.
Attach Support Legs
1. Determine the correct slots on the tray side from the type of
exterior construction of the building.
Thin Wall Construction (vinyl, wood, etc.)
Thick Wall Construction (brick)
A. Tray back
B. Windowsill
C. Outside edge of stool
A
B
C
A. Tray back
B. #8 - 18 x
¹⁄₄
" hex-head screws
C. Tray side
A. First and second slots
A. Second and third slots
A
B
C
A
A