Filter
Top Products
13
2. Using 2 - #10 - 12 x 1¹⁄₂" slot-head wood screws, secure the
tray-frame assembly to the wall opening.
Left Side
Right Side
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
3. With tray center pushed away from the windowsill, place a
level on the angled edge on top of the tray side. Be sure level
is against notch on tray side.
4. Adjust SMART-MOUNT
®
tray until bubble indicates the
angled edge on top of the tray side is level.
IMPORTANT: The tray must slope downward slightly toward
the outside to provide proper drainage for the air conditioner.
5. Tighten the hex nut just enough to hold tray center in place.
6. Repeat with other side.
7. Tighten hex nuts securely with ⁷⁄₁₆" wrench.
Position the Air Conditioner Through the Wall
■ Handle air conditioner gently.
■ Be sure your air conditioner does not fall out of the opening
during installation or removal.
■ Do not block the louvers on the front panel.
■ Do not block the louvers on the outside of the air conditioner.
1. Place the air conditioner in the SMART-MOUNT
®
tray. Check
that feet on bottom of air conditioner are resting on the ³⁄₄"
(1.9 cm) x 2" (5 cm) wood strip at the bottom of the wall
opening and the top channel rests against the top of the wall
opening.
A. #10 - 12 x 1
¹⁄₂
" slot-head wood screw
A. #10 - 12 x 1
¹⁄₂
" slot-head wood screw
A
A
A. Angled edge on top of the tray side
B. Notch
A. Bubble indicates the angled edge on top of the tray side is level.
B. Place level on angled edge against notch on tray side.
A
B
A
B
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.
A. SMART-MOUNT
®
tray
B. Feet on bottom of air conditioner resting on wood strip
B
A