Filter
Top Products
Operating Your Air
Conditioner
In order to obtain the best possible results from your air conditioner, it is important that you
operate it properly. This section will tell you how to do just that.
Starting your air conditioner
Fire Hazard
Do not use an extension cord.
Doing so can result in death, fire, or
electrical shock.
NOTE: Make sure air conditioner System
Control is set to Unit Off before plugging in
the unit.
1. Set the Exhaust Control to Closed for
best cooling results.
2. Set the System Control to the
desired setting.
LO COOL . . . . . . . . . . . for sleeping comfort
MED COOL
. . . . . . . . . . for normal cooling
HI COOL . . . . . . . . . . for maximum cooling
FAN ONLY
. . . . ..for air circulation only
3. Turn the Thermostat Control to the mid
(number 6) setting. You can adjust the air
conditioner’s cooling performance by
resetting the Thermostat Control to a
higher number for maximum cooling.
Lower the thermostat for less cooling.
You will need to experiment to find the
setting which suits you best.
When lowering the Thermostat Control
setting, the compressor (motor) may
shut off.
NOTE: When the compressor is turned off
with either the system control or the thermo-
stat control, wait at least two minutes before
restarting the air conditioner or turning the
compressor back on.
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Failure to follow these instructions
can result in death or electrical shock.
5