Whirlpool ACE082XS0 Air Conditioner User Manual


 
For Heating
NOTE: This product Is not deolgned to be used as a primary heat source. It Is intended for
supplemental heating only.
LO HEAT
Turn THERMOSTAT CONTROL to the mid
for reduced air (number 6) setting. You can adjust the air con-
movement with heat. ditioner’s heating performance by resetting the
HI HEAT
thermostat control to a lower number for more
for maximum air
heat. Turn to a higher number for less heat.
movement with heat.
Model ACH082 ONLY
Use of the heat settings on this model activates a reverse cycle operation that works as a heat pump.
It changes the operating mode of the refrigeration system to provide supplemental heat for chilly days
and evenings. When raising the thermostat in this heating mode, the compressor (motor) may shut off.
When the compressor is turned off with either the fan speed control or the thermostat control, wait 2-3
minutes before restarting the air conditioner or turning the compressor back on. This should prevent
blowing a fuse or tripping a circuit breaker. Use of this feature is not recommended when the
outslde temperature is below 45°F.
Using the Exhaust Control
This control setting can be used to draw stale or smoky air from the room or to circulate air in the
room, without cooling or heating. NOTE: Make sure the exhaust vent control Is returned to the
CLOSED sefflng when cooling, heating or room alr circulation is desired. Energy etflclency is
decreased when operating In EXHAUST and cooling or heating at the same time.
1.
To exhaust room air:
l Set EXHAUST VENT control to OPEN.
l If cooling is desired, set FAN SPEED
CONTROL to desired COOL setting.
l If heating is desired, set FAN SPEED
CONTROL to desired HEAT setting.
l If cooling or heating is not required, set
FAN SPEED CONTROL to FAN ONLY.
2. To circulate room air:
l Set EXHAUST VENT control to CLOSED.
l If cooling is desired, set FAN SPEED
CONTROL to desired COOL setting.
l If heating is desired, set FAN SPEED
CONTROL to desired HEAT setting.
l If cooling or heating is not required, set
FAN SPEED CONTROL to FAN ONLY.